1. One flashlight, six gels
Gels are transparent colored sheets that go over the light (ExpertPhotography). Draw the outer arc in red, swap the gel, draw the next arc a little lower in orange, and so on. Use Bulb mode, because six passes take time.
2. An RGB LED wand
A wand that changes color at the press of a button saves the gel swaps; pixel sticks can even paint a full rainbow gradient in one walk (Wikipedia). See light painting wand.
3. Color filters and hoods on a brush
Brush systems sell screw-on color filters and hoods that snap onto the flashlight (Light Painting Brushes).
4. A rainbow brush in AR
Neon Glow Draw takes a different route: it is not a long-exposure camera and doesn't record real light. It draws virtual neon strokes in the camera view with augmented reality. You hold a finger on the screen and move the iPhone, the line appears in the air, and it stays anchored in the room while you walk around it and record a video. Its rainbow mode and rainbow ribbon draw every color in a single stroke, in a lit room, recorded as video.
Step by step (gel method)
- Put the camera on a tripod in the dark and set Bulb mode, ISO 100 and f/8.
- Mark the two ends of the arc on the floor with tape.
- Start the exposure and draw the top arc with a red gel over the flashlight.
- Turn the light off, swap to orange and draw the next arc just below.
- Repeat with yellow, green, blue and violet.
- Close the shutter and check that the bands touch without overlapping.
Tips
- Yellow and green look brighter than blue and violet; draw those arcs a little faster so the bands look even.
- Mark the start and end points of the arc with two pieces of tape on the floor.
- Dark clothes keep you out of the photo (ExpertPhotography).